High Aspect Ratio
High stretch (AR = 18) keeps the induced drag low.
High Altitude Flying in the low density low friction environment around FL500.
The Wing is particularly optimized for high Levels, but not only:
The “Top Wing” configurations is less prone to shed vortices/induced-drag from the fuselage if designed well. Combined Lift Effects at High AOA especially with Slats and Flaps extended can be designed to significantly higher Lift-Coefficients. That may be the main cause why Darwin had the birds grow their wings on top.
Back to contents ↑
Large aircraft automatically provide large space for fuel accomodation since
Volume ≃ L³.
For a small aircraft with large fuel requirement, the wing or wing tanks become over-proportionally bulky. Wing decoupling for fuel requirement is one of the keys to success. The fuselage itself offers a large geometry for such a main tank. Little additional surface is hereby generated particularly if such fuel tank can be located near the largest cabin prosection area.
If one needs bring a large amount of fuel in a relatively small aircraft, a new location concept inside fuselage becomes crucial.
A wing only driven by aerodynamics and stress analysis can be designed slender and thin.
Needless to say The PJ III also uses – like industry standard - a laminar & supercritical profile, to achieve the speed of M=.76
Short chord (MAC 0.85 m) keeps the Reynolds number small, reduces boundary-layer thickness and therefore minimizes skin-friction and parasite drag.
The fuselage shape is coupled with the wing and its high-lift devices to achieve efficient short-field performance.
Relocating the main fuel volume from the wing into the fuselage enables the slender, high-altitude wing configuration.
The PJ III short-field capability results from a set of mutually supporting design features.
The compact dolphin- / egg-shaped fuselage supports a lightweight overall structure. A very short yet spacious fuselage/cabin arrangement combines cockpit, lavatory, passenger section, center tank and wheel bay within one integrated concept.
Slats increase lift by about 50% without much extra drag.
Additional lift is generated by the ideal high-wing and wing/fuselage configuration.
Ground effect is enhanced by a deep flap and by gap sealing towards the fuselage.
Larger-than-usual high-lift devices further support short-field performance, with flap portions of about 35–47% and slat portions of about 25% of wing chord.
High static thrust – near 40% of aircraft weight – completes the short takeoff concept.
A laminar profile is transformed into a three-dimensional body of revolution.
Nature uses non-cylindrical shapes based on continuously changing, streamlined body sections.
Cylindrical forms are avoided for a reason.
The resulting fuselage geometry follows the same aerodynamic principle, shown here in a view from below.